During hardware installation, a Windows message may call attention to the fact that the hard-
ware driver has not passed Windows Driver Signing. This is an expected behavior and does not
indicate a problem. Nonetheless, you need to turn off Windows User Account Control (UAC)
before you can proceed. See chapter ↑6.2, User Account Control and Internet Security in this
Setup Guide for detailed information on how to turn off UAC. In addition to turning off UAC, it
may be necessary to disable your anti-virus software during installation.
Windows XP Users Only: Completing the Device Driver Installation
Upon detection of the new hardware, Windows completes the device driver installation:
1. Windows XP will identify the TRAKTOR KONTROL Z2. Choose No if Windows asks you to
search the internet for a driver.
2. During device driver installation, a Windows message may call attention to the fact that
the driver has not passed Windows Logo Testing. This is an expected behavior and does
not indicate a problem. To proceed, click Continue Anyway.
→
Your computer will display a “New Hardware found” message. Subsequently, another
message reading “Your devices are ready to use” will notify you that the device driver in-
stallation was completed successfully.
4.4 Connecting Headphones
Before putting on headphones, always make sure the headphone volume control (HP VOL-
UME knob on the Z2's top panel) is set to minimum! Later on, slowly increase the head-
phone volume while music is playing until it reaches the desired listening level.
To connect your headphones to the TRAKTOR KONTROL Z2:
Setting Up Your TRAKTOR KONTROL Z2 System
Connecting Headphones
TRAKTOR KONTROL Z2 - Setup Guide - 36
To Next Page
Loading...
Need help?
General
