Native Instruments Traktor Kontrol Z2 Setup Guide

4.8.1 Connect the Left CD Player
1. Connect the left and right audio output cables of the left CD player (L) to the LINE A RCA
inputs of the Z2's INPUT section.
2. Make sure the phono/line switch for channel A (on the Z2's top panel) is set to LN for line
level amplification.
Notice that the TRAKTOR button next to the switch is unlit. This means that channel A is
operating in Direct mode and that the channel will bypass the TRAKTOR software for
stand-alone operation. For controlling TRAKTOR with Timecode media, you will need to ac-
tivate TRAKTOR mode later on. You will find further information on the Z2's operation
modes later in this document and in the TRAKTOR KONTROL Z2 Manual.
Setting Up Your TRAKTOR KONTROL Z2 System
Connecting CD Players
TRAKTOR KONTROL Z2 - Setup Guide - 46

Native Instruments Traktor Kontrol Z2 Specifications

General

Frequency range	20 - 20000 Hz
Channels quantity	6 channels
Supported sample rates	48 kHz
Digital sound processing	24 bit
AUX in	Yes
XLR out	2
AUX out ports	1
Headphone connectivity	3.5 mm/6.35 mm
Product color	Black
USB connector type	USB Type-A, USB Type-B
AC input voltage	115 - 230 V
Power consumption	750 mA
AC input frequency	50 - 60 Hz
Minimum storage drive space	1024 MB
Mac operating systems supported	Mac OS X 10.12 Sierra, Mac OS X 10.13 High Sierra, Mac OS X 10.14 Mojave, Mac OS X 10.15 Catalina
Windows operating systems supported	Windows 10