To Next Page

To Previous Page

Instructions for Use XLTEK Protektor32

Multiple Connections

You can monitor more than one Acquisition Station by more than one Remote Station. The following

configurations below are the available:

Both Local Portal (LP) and Remote Portal (RP) can run on the same station at the same time.

• RP can connect to several acquisition stations (nLP) and monitor them at the same time (one-to-

many monitoring).

• LP can accept several observers (nRP) at the same time (many-to-one monitoring).

• Above three points give many-to-many monitoring where all topologies (including loops) are allowed.

• LP-nRP textual chat.

Additional Information and Terms

Bandwidth – is the total amount of EPWorks data being sent to the observer (the units are in

bytes/second

• Messages – refers to how many messages per second are being sent to the observer (data is

passed in messages)

• Queue – refers to how many messages are currently in the process of going across to the observer

• Remote monitoring Optimizations – These are all optimizations that can reduce system load and

network load both on the acquisition system and the remote system

• SSEP by default, not every single “intermediate” sweep is send of an averaged waveform in

order to save bandwidth. The user can specify how frequently the intermediate sweeps are

sent (final completed sweeps are always sent).

• Update free run EMG every n seconds – this saves network bandwidth by sending sweeps

every few seconds. The user can specify 0 and it will send the data as soon as they have it.

• Accumulated EEG – this specifies how “smoothly” the EEG on the remote system will be

displayed. The more frequently it is sent, the more the network bandwidth it will use.

• Remote Monitoring – Physician will be able to add notes directly into the patient record “log book”

while connected remotely.

• Connectivity – a message will appear on both the acquisition system and the remote monitoring

system if a network connection is lost and also when the connection is reestablished..

natus XLTEK Protektor32 User Manual

Questions and Answers: