Nautilus E614 User Manual

31
2. Using a 6mm hex key and a 13 mm wrench, remove the two indicated
bolts from the Lower Handlebar Arms and Pedals. Set the hardware safely
aside for reassembly.
Be aware that the Handlebar Arms will be loose and
may pivot when the hardware is removed. This step
may require two people.
3. Using a small flathead screwdriver, pry the Caps
from the Lower Handlebar Arms.
4. Using a 13 mm wrench, remove the hardware from the
Lower Handlebar Arms and the Arm Pivot Rod. Remove the
hardware, Upper and Lower Handlebar Arms, and Arm Pivot
Rod. Set them safely aside for reassembly.
5. Using a 6mm hex key, loosen and remove the indicated hardware
from the Legs, and set it safely aside for reassembly. On each side of the
machine, remove the Leg and Pedal together from the Rail Assembly and
set them safely aside for reassembly.
NOTICE: This step may require two people.
X2
6mm
X2
X2
13 mm
X2
6mm
X2

Nautilus E614 Specifications

General

Brand	Nautilus
Model	E614
Category	Elliptical Trainer
Language	English