62
A
B
C
9. Bend the edges of the Top Shroud to disengage the inside tabs from
the Main Assembly, and slide the Shroud Cap and Top Shroud up the
Mast.
10. Remove the hardware (indicated) from the Mast. Gently pull the Mast
out and disconnect the cables. Set the hardware and Top Shroud safely
aside for reassembly.
NOTICE:'RQRWFULPSWKHFDEOHV'RQRWDOORZWKH'DWD&DEOHWR
fall down into the Main Unit. This step may require two
people.
11. Tie the length of string to the end (A) of the Lift Motor Wire at the
base of the Mast. Hold the other end of the Lift Motor Wire (B) and
carefully pull it out of the Mast so that the string extends through the
length of the Mast.
NOTICE:+ROGWKH'DWD&DEOH&VRWKDW\RXGRQRWSXOOLWRXWRIWKH
0DVW'RQRWFULPSWKH'DWD&DEOH
12. Untie the string from the old Lift Motor Wire and discard the old cable.
13. Tie the end of the string at the base of the Mast to one end of the
replacement Lift Motor Wire. Hold the other end of the string and carefully
pull the new Lift Motor Wire through the Mast.
NOTICE:+ROGWKH'DWD&DEOH&VRWKDW\RXGRQRWSXOOLWRXWRIWKH
0DVW'RQRWFULPSWKHFDEOHV
14. Connect the new Lift Motor Wire to the Lift Motor Wire from the Main
)UDPH5HFRQQHFWWKH'DWD&DEOHVIURPWKH0DVWDQGWKH0DLQ)UDPH
NOTICE:'RQRWFULPSWKHFDEOHV7KLVVWHSPD\UHTXLUHWZRSHRSOH
15. Reassembly is the reverse procedure.
NOTICE:'RQRWFULPSWKHFDEOHV8QWLHWKHVWULQJIURPWKH/LIW
0RWRU:LUH'RQRWDOORZWKHFDEOHVWRIDOOGRZQLQWRWKH
Console Mast.
Be sure the tabs in the Top Shroud snap into the Main
Assembly.
16. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
C
A
6mm
X4
To Next Page
Loading...
Need help?
General
