To Next Page

To Previous Page

The Console Setup Mode lets you input the date and time, set the units of measurement to either English or Metric,

control the sound settings ( on/ off), or see maintenance statistics (Error Log and Run Hours – for service technician use

only).

1. Hold down the PAUSE/END button and Increase button together for 3 seconds while in the Power-Up Mode to go into

the Console Setup Mode.

Note:PushPAUSE/ENDtoexittheConsoleSetupModeandreturntothePower-UpModescreen.

2. The Console display shows the Date prompt with the current setting. To change, push the Increase/Decrease buttons

toadjustthecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttonstochangewhichsegmentisthecurrently

active value (month / day / year).

3. Push OK to set.

4. The Console display shows the Time prompt with the current setting. Push the Increase/Decrease buttons to adjust

thecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttonstochangewhichsegmentisthecurrentlyactivevalue

(hour / minute / AM or PM).

5. Push OK to set.

6. The Console display shows the Units prompt with the current setting. To change, push OK to start the Units option.

Push the Increase/Decrease buttons to change between “MILES” (Imperial English units) and “KM” (metric units).

Note: If the units change when there is data in User Statistics, the statistics convert to the new units.

7. PushOKtoset.

8. The Console display shows the Sound Settings prompt with the current setting. Push the Increase/Decrease buttons

to change between “ON” and “OFF”.

9. Push OK to set.

10. The Console display shows the TOTAL RUN HOURS for the machine.

11. Forthenextprompt,pushtheOKbutton.

12. The Console display shows the Software Version prompt.

13. Forthenextprompt,pushtheOKbutton.

14. The Console will display the Power-Up Mode screen.

CONSOLE SETUP MODE

Nautilus E628 User Manual

Questions and Answers: