Nautilus T624 - Page 141

141
46. The hydraulic lift is set up to drop gradually. Hold onto the walking deck until approximately 2/3 of the movement down. Make sure that you use
proper lifting technique; bend your knees and keep your back straight. Be aware that the walking deck can possibly drop quickly in the last part of the
movement.
Ifyouusedspraylubricant,wait5minutesbeforeturningonpowertothemachinetoallowtheaerosoltodissipate.
47.AttachthepowercordandturnontheTreadmillbyippingthepowerswitchtoON.
48.Staytoonesideofyourmachineandstartthebeltattheslowestspeed.Letthebeltoperateforapproximately15seconds.
Be sure not to touch the walking belt or step on the power cord. Keep bystanders, children and pets away from the machine you are servicing
at all times.
49. Switch off your machine.
50.Takecaretocleanupanyexcesslubricantfromthedeck.
To decrease the possibility of slipping, be sure the deck area is free from grease or oil. Clean off any excess oil from the machine surfaces.
51.TurnontheTreadmillbyippingthepowerswitchtoON.
52.FromthePowerUp(orWelcome)screen,pushandholddownthePAUSE/STOPbuttonandRightarrowbuttonforabout5secondstogointo
the Console Setup Mode. The Console display will show the Date prompt with the current setting.
53.PushtheOKbutton4timesuntiltheConsoledisplaystheTOTALRUNHOURSscreen.
54.PushandholddownthePAUSE/STOPbuttonandRightarrowbuttonforabout5secondstogointotheEngineeringMode.TheConsoledisplay
will show the current Firmware Version.
55.PushtheDownarrowbutton4timesuntiltheConsoledisplays“RUNMCBCAL”.
Be sure the area around the Treadmill is clear of all bystanders, children and pets . Be sure there is nothing on or under the Walking Belt, or
near the Treadmill.
56.Withtheareaclear,pushtheOKbutton.ThecalibrationprocedurewillbeginbyautomaticallymovingtheWalkingBeltandliftingtheDeck
through the full range of incline motion.
Be sure not to touch or allow anyone else to touch the machine while calibration is occurring.
57.Whencalibrationiscomplete,theConsolewilldisplay“done”forafewseconds,andthenreturntothe“RUNMCBCAL”option.
58.FlipthepowerswitchtoOFF.Calibrationisnowcompleteforthemachine.