7
Earthing Instructions
This product must be electrically earthed. If a malfunction occurs, correct earthing decreases the risk of electric shock. The
power cord is equipped with an equipment-earthing conductor, and must be connected to an outlet that is properly installed
and earthed.
The electrical wiring must comply with all applicable local and provincial standards and requirements.
Incorrect connection of the equipment-earthing conductor can result in a risk of electric shock. Consult a
licensed electrician if you are not sure that the machine is correctly earthed. Do not change the plug on the
machine – if it does not fit the outlet, have a correct outlet installed by a licensed electrician.
If you connect the machine to an outlet with RCBO (Residual-Current circuit Breaker with Overload protection), machine
operation can cause the circuit to trip. A Surge Protector Device is recommended to protect the machine.
!
If a Surge Protector Device (SPD) is used with this machine, be sure that it matches the power rating of this equipment
(220-240V AC). Do not connect other appliances or devices to the surge protector in combination with this machine.
Make sure that the product is connected to an outlet having the same configuration as the plug. No adapter should be
used with this product.
Emergency Stop Procedure
The Treadmill machine is equipped with a Safety Key that can prevent serious injury, as well as prevent children from playing
with and/or being injured on the machine. If the Safety Key is not correctly inserted into the Safety Key Port, the belt will not
operate.
!
Always attach the Safety Key Clip to your clothing during your workout.
When you use the machine, only remove the Safety Key in an emergency. When the key is removed while the machine
is in operation, it will stop quickly, which could cause the loss of balance and possible injury.
For safe storage of the machine, and to prevent unsupervised operation of the machine, always remove the Safety Key
and disconnect the power cord from the wall outlet and the AC input. Place the power cord in a secure location.
The Console will display “ + SAFETY KEY ”, or add Safety Key, for a Safety Key fault. The Treadmill machine will not start a
Workout, or will end and clear an active Workout, when the Safety Key is removed. Inspect the Safety Key and be sure it is
connected to the Console correctly.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
