68 Configuring the Remote Controller System
4.11 Canceling all Timer Settings
Press and hold the Preheat & Timer and OK button
simultaneously for 2 seconds.
“CLR” appears for 3 seconds and all timer settings
are canceled.
2 sec
5. During the reservation schedule, the preheating
icon turns on and the Reservation area starts
flashing.
4.10 Starting Recirculation
Press the Preheat & Timer button to start
recirculation immediately, regardless of the
reservation schedule.
“HEAT” appears for 4 seconds on the display and
then recirculation runs once.
During the recirculation, the preheating icon flashes
continuously.
Note
●
This feature is available only when
external circulating pumps are
connected and ON.
●
This feature runs during the
recirculation time set on the front
panel which the remote controller is
connected to.
To Next Page
Loading...
Need help?
General
