NCE Power Cab - Dropping a Locomotive from an Advanced Consist; Adding a Loco to an Advanced Consist

29
Enter the rear loco number followed by the ENTER key.
NOTE: If you plan on dropping the rear loco from the consist later on, DO NOT enter
it as the rear loco. Enter it later on when prompted for mid-consist locos.
ENTERING THE REAR LOCO DIRECTION
If the locomotive is to operate in the normal direction press ENTER. Press the
DIRECTION key if you wish to have the locomotive operate in the reverse direction.
Subsequent presses of the DIRECTION key will keep changing the direction. When
you get the direction you desire press the ENTER key.
CONSIST 2:00PMCONSIST 2:00PM
CONSIST 2:00PMCONSIST 2:00PM
CONSIST 2:00PM
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: F
ADDING A MID-CONSIST LOCO
At this point you can start to add more locomotives to the consist. Enter the next
locomotive (decoder address) followed by pressing the ENTER key. If you don’t
want to add any more locomotives to the consist just press ENTER.
CONSIST 2:00PMCONSIST 2:00PM
CONSIST 2:00PMCONSIST 2:00PM
CONSIST 2:00PM
ADD LOCO: _ADD LOCO: _
ADD LOCO: _ADD LOCO: _
ADD LOCO: _
ENTERING THE LOCO’S DIRECTION
CONSIST 2:00PMCONSIST 2:00PM
CONSIST 2:00PMCONSIST 2:00PM
CONSIST 2:00PM
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: F
As with the lead locomotive, this informs the decoder if the loco is in the line-up facing
forward or reverse.
If the locomotive is to operate in the normal direction press ENTER. Press the
DIRECTION key if you wish to have the locomotive operate in the reverse direction.
Subsequent presses of the DIRECTION key will keep changing the direction. When
you get the direction you desire press the ENTER key.
At this point you will be prompted to add additional locomotives. If you don’t want to
add any more locomotives to the consist just press ENTER or PROG/ESC with out
entering an address.
DROPPING A LOCOMOTIVE FROM AN ADVANCED
CONSIST
To delete a consist locomotive press DEL
DEL LOCO 2:00PMDEL LOCO 2:00PM
DEL LOCO 2:00PMDEL LOCO 2:00PM
DEL LOCO 2:00PM
ENTER LOCO: _ENTER LOCO: _
ENTER LOCO: _ENTER LOCO: _
ENTER LOCO: _
This will drop the loco identified from whatever consist it was part of. There is no
need to know the consist number for this operation. You cannot drop a lead or rear
loco without clearing the entire consist. Deleting a loco sets CV19 to a value of 0 in
that loco.
ADDING A LOCO TO AN ADVANCED CONSIST
Select the consist.
ADD LOCO 2:00PMADD LOCO 2:00PM
ADD LOCO 2:00PMADD LOCO 2:00PM
ADD LOCO 2:00PM
CONSIST ADDR: _CONSIST ADDR: _
CONSIST ADDR: _CONSIST ADDR: _
CONSIST ADDR: _
Press ADD . Enter the address of the consist, or lead loco, to which the loco is to be
added and then press the ENTER key.