NCE Power Cab - Setting the Cab Parameters; Function Refresh Rate; Momentum Deceleration Rate; System Reset

59
multiplication factor. You can set it from 0-25. Press ENTER to skip setting this
parameter.
MOMENTUM DECELERATION RATE (default is 0=HALF)
The deceleration rate (CV4) when pressing the momentum button can be either half
the value sent for acceleration (CV3) or the full value sent to CV3. Factory default is
½. Press ENTER to skip setting this parameter.
MOMEN DECEL RATEMOMEN DECEL RATE
MOMEN DECEL RATEMOMEN DECEL RATE
MOMEN DECEL RATE
1=FULL 0=HALF 01=FULL 0=HALF 0
1=FULL 0=HALF 01=FULL 0=HALF 0
1=FULL 0=HALF 0
FUNCTION REFRESH (default is 0=OFF)
Function Refresh will keep the lights and sounds working (F0 through F8) on
locomotives that don’t remember the state of their functions on start up and dirty
track. The Function Refresh rate is set to occur about once per second. If all
functions are OFF or the locomotive speed is Zero (0), the functions for that
locomotive will not be refreshed.
FUNCTION REFRESHFUNCTION REFRESH
FUNCTION REFRESHFUNCTION REFRESH
FUNCTION REFRESH
ENABLE 1=Y 0=NENABLE 1=Y 0=N
ENABLE 1=Y 0=NENABLE 1=Y 0=N
ENABLE 1=Y 0=N
RESET SYSTEM?
Reset System will reset all of the system configuration settings to their factory
defaults. Only the Power Cab memory will be reset, the memory as a Pro Cab will
remain.
RESET SYSTEM?RESET SYSTEM?
RESET SYSTEM?RESET SYSTEM?
RESET SYSTEM?
PRESS 6 FOR YESPRESS 6 FOR YES
PRESS 6 FOR YESPRESS 6 FOR YES
PRESS 6 FOR YES
Press 6 to enter the Reset action.
ARE YOU SURE?ARE YOU SURE?
ARE YOU SURE?ARE YOU SURE?
ARE YOU SURE?
PRESS 1 FOR YESPRESS 1 FOR YES
PRESS 1 FOR YESPRESS 1 FOR YES
PRESS 1 FOR YES
The system will reset itself and take you back to the opening screen.
SET UP THE CAB PARAMETERS
(Shortcut = PROG 6)
SHOW TRACK CURRENT:
SHOW 02:00PMSHOW 02:00PM
SHOW 02:00PMSHOW 02:00PM
SHOW 02:00PM
TRK CURRENT? 1=YTRK CURRENT? 1=Y
TRK CURRENT? 1=YTRK CURRENT? 1=Y
TRK CURRENT? 1=Y
Press 1 to enable the display of current being supplied to the main running track by
the system when in normal operations mode. Current display will be cancelled by
programming on the main, using the program track, or cycling the system power.