NCE Power Cab - Program Accessory Decoders on the Main; Program Macros; Program Accessory Decoders

61
PROGRAM ACCESSORY DECODERS
(Shortcut = PROG 7)
This allows the operator to set Accessory Decoder CVs while they are connected to
the Track (Accessory Programming on the Main).
ENTER THE ACCESSORY ADDRESS
Enter the Accessory Decoder address and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ACC. ADDR: _ACC. ADDR: _
ACC. ADDR: _ACC. ADDR: _
ACC. ADDR: _
ENTER THE CV NUMBER
Enter the CV number that you want to program and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ENTER CV NUM:_ENTER CV NUM:_
ENTER CV NUM:_ENTER CV NUM:_
ENTER CV NUM:_
ENTER THE CV VALUE
Enter the value you want in the CV and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ENTER VALUE: _ENTER VALUE: _
ENTER VALUE: _ENTER VALUE: _
ENTER VALUE: _
For Compatibility, both “legacy” and new style programming commands are issued to
Accessory Decoders.
PROGRAM MACROS
(Shortcut = PROG 8)
This allows the operator to program Macros (switch lists).
SELECT MACRO PROGRAM OR REVIEW
Press 1 to program a Macro or press 2 to review a programmed Macro.
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PM
1=PROG 2=REVIEW1=PROG 2=REVIEW
1=PROG 2=REVIEW1=PROG 2=REVIEW
1=PROG 2=REVIEW
If 1 is pressed the following screen is displayed.
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PM
MACRO NUMBER:_MACRO NUMBER:_
MACRO NUMBER:_MACRO NUMBER:_
MACRO NUMBER:_
ENTER THE MACRO NUMBER
Enter the Macro number that you want to program (0-15), and press ENTER.