NCE Power Cab - Number of Accessory Packets; Number of Horn off Packets; Number of Program Packets; Send Function Commands to Consist Address

58
NUMBER OF ACCESSORY PACKETS (default is 4)
This adjusts the number of accessory control commands sent when an accessory
or signal is controlled. Factory default is 4. Press ENTER to skip setting this
parameter.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
OF ACC PKTS: 004OF ACC PKTS: 004
OF ACC PKTS: 004OF ACC PKTS: 004
OF ACC PKTS: 004
NUMBER OF HORN OFF PACKETS (default is 2)
This adjusts the number of times a “horn off” packet is sent when the HORN button
is released. The factory default is 2 but can be set as high as 16. Press ENTER to
skip setting this parameter.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
HORN OFF PKT 002HORN OFF PKT 002
HORN OFF PKT 002HORN OFF PKT 002
HORN OFF PKT 002
NUMBER OF PROGRAM PACKETS (default is 4)
This adjusts the number of times a programming command is sent when
programming a locomotive on the mainline. Factory default is 4. Press ENTER to
skip setting this parameter.
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PMNUMBER 02:00PM
NUMBER 02:00PM
OF PROG PKTS 004OF PROG PKTS 004
OF PROG PKTS 004OF PROG PKTS 004
OF PROG PKTS 004
SEND FUNCTION COMMANDS TO CONSIST ADDRESS
(default is 1=Y)
Function commands are normally sent to the lead loco of an advanced consist. They
can also be sent to the consist address so that other locomotives in consist can
react to these commands if desired. The factory default is yes. Press ENTER to skip
setting this parameter.
SEND FUNCTION TOSEND FUNCTION TO
SEND FUNCTION TOSEND FUNCTION TO
SEND FUNCTION TO
CON? 1=Y 0=N 1CON? 1=Y 0=N 1
CON? 1=Y 0=N 1CON? 1=Y 0=N 1
CON? 1=Y 0=N 1
CONSIST MOMENTUM (default is 1=Y)
You can disable the momentum button on all handheld cabs that are operating a
consist. The buttons are enabled by factory default. Press ENTER to skip setting this
parameter.
CONSIST MOMENTUMCONSIST MOMENTUM
CONSIST MOMENTUMCONSIST MOMENTUM
CONSIST MOMENTUM
ENABLE 1=Y 0=N 1ENABLE 1=Y 0=N 1
ENABLE 1=Y 0=N 1ENABLE 1=Y 0=N 1
ENABLE 1=Y 0=N 1
MOMENTUM MULTIPLIER (default is 8)
When you press the MOMENTUM button you are prompted for a single digit
indicating how much momentum you want for the loco/consist you are controlling.
Momentum CVs have a range of 0-255 while the button asks for values from 0-9.
MOMENTUM BUTTONMOMENTUM BUTTON
MOMENTUM BUTTONMOMENTUM BUTTON
MOMENTUM BUTTON
MULTIPLIER: 08MULTIPLIER: 08
MULTIPLIER: 08MULTIPLIER: 08
MULTIPLIER: 08
The value you enter for the momentum button is multiplied by this parameter (factory
default of 8) and sent to CV3 in the locomotive. This parameter adjusts the