NCE Power Cab - Entering the Minute; Entering the Ratio; Starting the Clock

47
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PM
ENTER HOURS: _ENTER HOURS: _
ENTER HOURS: _ENTER HOURS: _
ENTER HOURS: _
ENTERING THE MINUTE
Enter the starting minute. Use 0 through 59. Press ENTER.
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PM
ENTER MINUTES: _ENTER MINUTES: _
ENTER MINUTES: _ENTER MINUTES: _
ENTER MINUTES: _
ENTERING THE RATIO
Enter the ratio that the clock should run at with 1 being the normal speed. The ratio
can be any number from 1 (1:1) to 15 (15:1). Press ENTER.
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PMSET TIME 02:00PM
SET TIME 02:00PM
ENTER RATIO: _ENTER RATIO: _
ENTER RATIO: _ENTER RATIO: _
ENTER RATIO: _
STARTING THE CLOCK
If the clock was stopped, entering SET THE SYSTEM CLOCK will display this screen
to let you start (or restart) the clock. Press 1 to start the clock, press ENTER to
leave the clock stopped and continue with clock programming (see above).
START? 02:00PMSTART? 02:00PM
START? 02:00PMSTART? 02:00PM
START? 02:00PM
ENTER=NO 1=STARTENTER=NO 1=START
ENTER=NO 1=STARTENTER=NO 1=START
ENTER=NO 1=START