32
ENTERING THE LOCO DIRECTION
OLD TYPE 2:00PMOLD TYPE 2:00PM
OLD TYPE 2:00PMOLD TYPE 2:00PM
OLD TYPE 2:00PM
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: FDIR THIS LOCO: F
DIR THIS LOCO: F
The locomotive direction is assumed to be forward, if it is to operate in reverse press
the DIRECTION key. This informs the command station whether the loco is in the
line-up facing reverse. This affects only the direction of the loco, not lighting. Press
the ENTER key to continue.
This operation leaves the consist as the active unit for this Cab. By pressing
RECALL the operator can change to another loco/consist but the old style consist
will stay with this Cab until it is either passed to another Cab (by assigning it) or the
consist is cleared.
OLD STYLE CONSIST FULL
OLD TYPE 2:00PMOLD TYPE 2:00PM
OLD TYPE 2:00PMOLD TYPE 2:00PM
OLD TYPE 2:00PM
CONSIST NOW FULLCONSIST NOW FULL
CONSIST NOW FULLCONSIST NOW FULL
CONSIST NOW FULL
The consist contains two loco’s which is the maximum amount that we support in this
style of consist. Press the ENTER key to continue.
CLEARING AN OLD STYLE CONSIST
KILL? 02:00PMKILL? 02:00PM
KILL? 02:00PMKILL? 02:00PM
KILL? 02:00PM
ENTER=NO 1=YES:ENTER=NO 1=YES:
ENTER=NO 1=YES:ENTER=NO 1=YES:
ENTER=NO 1=YES:
Press 1 to clear the consist from the Command Station memory. All locomotives that
were in the consist may now be selected and operated independently.
VIEWING WHICH LOCOS ARE IN AND OLD STYLE
CONSIST
Press SETUP - The locos and their direction will be displayed. Press ENTER to
return to normal operation.
To Next Page
Loading...
