NCR 7600 - Page 94

4 BIOS Updating Procedure
Option2‐UpdateDMIonly‐Serial/Model/ClassupdateONLY(noBIOSUpdate)
ThisoptionletsyouentertheDMIinformationonly.TheBIOSisnotupdated.
1. HighlightOption2andpress[ENTER].
2. Atthepromptpress[ENTER] toentertheClass/Model/SerialNumber
information(DMI).Followtheonscreenformatinstructions.
Example: 7600-1000-8801[ENTER]
54-19378230
[ENTER]
3. Press[1]toconfirmthedataandtocontinue.
4. RemovetheUSBdevicebeforethesystemboots.
5. Systemisreadyforoperation.
Option3‐UpdateofBIOS‐AlwayspromptsforSerial/Model/Class
ThisoptionpromptsforClass/Model/Serialinformationatthebeginningofthe
programandthenupdatestheBIOSonly.
1. HighlightOption5
andpress[ENTER].
2. Atthepromptpress[ENTER]toentertheClass/Model/SerialNumber
information(DMI).Followtheonscreenformatinstructions.
Example: 7600-1000-8801[ENTER]
54-19378230
[ENTER]
3. Press[1]toconfirmthedataandtocontinue.
4. TheFlashProgramupdates theBIOSandautomaticallyrebootstheterminal.
Option4‐UpdateBIOS‐DefaultSerial/Model/Classinformation
ThisoptionisforServicePersonnelonly.ItupdatestheBIOSbutleavestheClass/
Model/Serialfieldsempty(erased).TheDMIinformationisthenentered
whenthe
boardisinstalledinaterminal.
1. HighlightOption4andpress[ENTER].
2. TheBIOSareupdatedandthesystemreboots.
3. RemovetheBIOSUpdatemediabeforethesystemboots.
4. Systemisreadyforoperation.