5-66 BIOS Updating Procedure
1 Update SPI and BIOS - No prompt for Serial/Model/Class unless invalid
(Resets ME/AMT configuration/provisioning data)
2 Update BIOS only - No prompt for Serial/Model/Class unless invalid
(Keeps ME/AMT configuration/provisioning data)
***** Forced Update of Serial/Model/Class Information *****
3 Update DMI only - Serial/Model/Class update ONLY (no BIOS/SPI Update)
(Only one boot - no need for AC Power removal)
4 Update of SPI and BIOS - Always prompts for Serial/Model/Class
(Resets ME/AMT configuration/provisioning data)
5 Update of BIOS only - Always prompts for Serial/Model/Class
(Keeps ME/AMT configuration/provisioning data)
***** For Service Personnel Only *****
6 Update SPI and BIOS - Default Serial/Model/Class. Reset ME/AMT data
Option 1 - Update SPI and BIOS - No prompt for Seri-
al/Model/Class unless invalid
1.
Highlight Option 1 and press [ENTER]. (Executes automatically in 10 seconds unless
the up/down arrow is pressed.)
2. The Flash Program updates the SPI/BIOS.
3. The Manageability Engine (ME) is programmed and a message is displayed
indicating power must be removed before continuing. Press [3] to perform a 20
second AC power removal (automatically executes in 10 seconds if no keys are
pressed).
4. Remove the USB device before the system boots.
5. System is ready for operation.
Option 2 - Update BIOS only - No prompt for Serial/Model/Class
unless invalid
This option automatically updates the BIOS only.
1. Highlight Option 2 and press [ENTER].
2. The Flash Program updates the BIOS and automatically reboots the terminal.
To Next Page
Loading...
