BIOS Updating Procedure 5-67
Option 3 - Update DMI only - Serial/Model/Class update ONLY
(no BIOS or SPI Update)
This option lets you enter the DMI information only. The SPI and BIOS are not updated.
1.
Highlight Option 3 and press [ENTER].
2.
At the prompt press [ENTER] to enter the Class/Model/Serial Number information
(DMI). Follow the onscreen format instructions.
Example: 7702-5000-8801[ENTER]
54-19378230[ENTER]
3.
Press [1] to confirm the data and to continue.
4. Remove the USB device before the system boots.
5. System is ready for operation.
Option 4 - Update of SPI and BIOS - Always prompts for Seri-
al/Model/Class
This option is similar to Option 1 above except you are prompted for Class/Model/Serial
information at the beginning of the program. You also have to select which type of
update to run, BIOS or SPI.
1.
Highlight Option 4 and press [ENTER].
2.
At the prompt press [ENTER] to enter the Class/Model/Serial Number information
(DMI). Follow the on-screen format instructions.
Example: 7702-5000-8801[ENTER]
54-19378230[ENTER]
3. Press 1 to confirm the data and to continue.
4. The Flash Program updates the SPI/BIOS and the Manageability Engine (ME) is
programmed.
5. A message is displayed indicating power must be removed before continuing. Press
[3] to perform a 20 second AC power removal (automatically executes in 2 minutes if
no keys are pressed).
6. Remove the USB device before the system boots.
To Next Page
Loading...
Need help?
General
