1
ii
CAUTION
This symbol alerts the user that important literature concerning the operation of this unit has been
included. Therefore, it should be read carefully in order to avoid potential problems.
This symbol warns user that un-insulated voltage within the unit may have sufficient magnitude to cause
electrical shock. Therefore, it is dangerous to make contact with any part inside the unit. To reduce the risk
of electric shock, DO NOT
remove cover (or back). There are no user serviceable parts inside. Refer
servicing to qualified service personnel.
To prevent fire or shock hazards, do not expose this unit to rain or moisture. Also, do not use this unit's polarized
plug with an extension cord receptacle or other outlets unless the prongs can be fully inserted. The display is
designed to meet the medical safety requirements for a patient vicinity device. This device may not
be used in
connection with life support equipment.
This equipment may not be used in the presence of flammable anesthetics mixture with air, oxygen or
nitrous oxide.
It is the responsibility of the installer to test the display’s earth ground to verify that it complies with the hospital,
local and national impedance requirements.
A ground post, located on the back of the display, may be used for the purpose of grounding the display’s chassis.
Any such ground must be installed in accordance with applicable electrical codes. The ground post is shown on
the mechanical drawing found on page 2.
Recycling:
Follow local governing ordinances and recycling plans regarding the recycling or disposal of this
equipment.
These monitors are powered by AC voltage from 100 to 240 volts at 50 to 60Hz.
Monitor is intended for continuous operation.
EEC Safety Compliance:
These display units meet the requirements of EN-60601-1 so as to conform to the Medical Device
Directive 93/42/EEC (general safety information).
Underwriters Laboratories (UL) Classification:
UL Safety Compliance:
These LCD monitors are U.L. Recognized WITH RESPECT TO ELECTRIC SHOCK, FIRE AND
MECHANICAL HAZARDS ONLY IN ACCORDANCE WITH UL 60601-1/CAN/CSA C22.2
NO. 601.1.
DEMKO
EN 60601-1
To Next Page
Loading...
Need help?
General