3
4
Press the Brightness / Contrast button three times, five times when a PIP image
is visible, to display the Backlight control. Press the ◄ or ► button to set the
backlighting.
Note: Lowering the backlight level will increase the backlight lifetime.
Adjust Backlight
Image Adjustments
Control
A 6 button keypad, located on the front of the display in the bottom right corner, allows the user to make
adjustments to various display parameters using the On Screen Menus (OSM) system.
Press the Brightness / Contrast button to display the Brightness control menu.
Press the ◄ or ► button to adjust Primary brightness. When a PIP image is
visible, press the Brightness / Contrast button again to access the Secondary
brightness control.
Setting the brightness too high or too low will decrease the amount of visible
grayscales.
Adjust Brightness
Press the Brightness / Contrast button twice, three times when a PIP image is
visble, to display the Contrast control menu. Press the ◄ or ► button to adjust
Primary contrast. When a PIP image is visible, press the Brightness / Contrast
button again to access the Secondary contrast control.
Setting the contrast too high or too low causes loss of some grayscales. Color
saturation may appear incorrect.
Adjust Contrast
To Next Page
Loading...
Need help?
General