Section 3: Features
Product Description 131
3
Warning Tone For Long Conversation
Description
The system can broadcast warning tones to a trunk caller warning them that they have been on the
call too long. The tones are just a reminder -- the user can disregard the tones and continue talking
if they choose. The outside caller does not hear the warning tones. In addition, warning tones do
not occur for Intercom calls and most incoming trunk calls. DISA trunks can also have warning
tones. Warning tones are not available to analog single line telephone (SLT) users.
There are two types of warning tones: Alarm Tone 1 and Alarm Tone 2. Alarm Tone 1 is the first
set of tones that occur after the user initially places a trunk call. Alarm Tone 2 broadcasts periodi-
cally after Alarm Tone 1 as a continued reminder. Each alarm tone consists of three short beeps.
Warning Tone for DISA Callers
For DISA callers, with this feature enabled, the warning tone timer begins when an incoming DISA
call places an outgoing call and either the inter-digit timer expires or the outgoing call is answered.
With this feature enabled, the warning tone timer begins when an incoming DISA call places an
outgoing call and either the inter-digit timer expires or the outgoing call is answered.
If an outside call is transferred to forwarded off-premise using an outside trunk, the warning tone
timer begins immediately. This will occur only if either trunk involved in the call is programmed
for this feature (Program 14-01-17). When transferring a trunk call off-premise, Program 14-01-13
must be enabled (set to ‘1’).
Aspire
• Available
To Next Page
Loading...
Need help?
General
