To Next Page

To Previous Page

9.1.18 To prevent the screen saver from blanking the screen after several minutes

From the Raspbian edit the following file as sudo: /etc/lightdm/lightdm.conf

Modify the following section to add the highlighted text:

[SeatDefaults]

xserver-command=X -s 0 –dpms

9.1.19 To enable IR Remote control using CEC from OSMC

Navigate to: Settings  System  Input  Peripherals  CEC Adapter

Enable the setting. A restart may be required before the CEC device can be detected by the display.

Use the supported CEC buttons on the NEC IR Remote. See Figure 3.4-3.

See sections 0, 8.15 and 8.16 for more information.

Note: Information as of OSMC version 2017.02-2

9.1.20 To enable IR Remote control using lirc from OSMC

Navigate to: My OSMC  Remotes.

Scroll to the correct IR remote type or “lircd-full” and select.

Make sure that “Disable RC6” on the bottom right isn’t selected.

Navigate to: My OSMC  Pi Config  Hardware support.

Select “Enable LIRC GPIO support”.

The use the default of gpio_in_pin = 18.

A restart may be required before lirc can be started.

See section 0 and 8.5 for more information.

Note: Information as of OSMC version 2017.02-2

9.1.21 Monitoring the system processes, CPU usage, and memory

The htop system tool is an interactive system-monitor process-viewer and process-manager that gives

visual information about processor, swap and memory status. Run from the command or terminal window:

htop

NEC C751Q User Manual

Other manuals for NEC C751Q