To Next Page

To Previous Page

8 Related OSD Settings

8.1 Compute Module menu  Power  Power Supply

Available options: On / Off

Controls power to the Compute Module.

If the Shutdown Signal is Enabled, selecting Off will set the shutdown signal and the Power Supply Off

Delay timer will start. Power to the Compute Module will be turned off once the timer has finished.

8.2 Compute Module menu  Power  Auto Power On

Available options: Enable / Disable

When set to Enable, power to the Compute Module will be turned on automatically when the display

power is turned on. If set to Disable, power to the Compute Module is manually controlled via either the

POWER SUPPLY setting on the COMPUTE MODULE OSD menu, or via the HTTP interface to the

display, or via a LAN command to the display (OpCode 117Ch).

Note that the Compute Module will remain on even when the display has been placed into Standby mode,

unless it is turned off via the POWER SUPPLY setting on the COMPUTE MODULE OSD menu, or via the

HTTP interface to the display, or via a LAN command to the display (OpCode 117Ch).

8.3 Compute Module menu  Service Menu  Setting Lock

Available options: On / Off

Access to other items on the SERVICE MENU is protected by a 4 digit password to prevent unauthorized

access. The password can be set on the Compute Module  CHANGE PASSWORD OSD menu. The

default password is 0 0 0 0.

The Setting Lock will default to On.

NEC C751Q User Manual

Other manuals for NEC C751Q