NEC Dterm DTL-8R-1 - Base Unit; Cordless Handset;Desk Phone Switch (Base Key Option); Figure 2-4 Base Unit Controls and Functions

2 - 6 About the D
term
Cordless DECT
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1 D
term
Cordless DECT
4.2 Base Unit
The Base Unit allows users to switch between the D
term
Cordless DECT
phone and the wired (desk) phone by using the Desk/Cordless buttons on the
unit.
4.3 Cordless Handset/Desk Phone Switch (Base Key Option)
If Base Key Option is on, One Touch Dial Keys 3 and 4 on the Handset are
used to switch between Desk Phone or Handset:
P Press and hold the One Touch Dial 3 key to switch to the Handset (same as the Cordless
Key on the Base Unit).
P Press and hold One Touch Dial 4 key to switch to the Desk Phone (same as the Desk key
on the Base Unit).
 When the Base Key Option is set, One Touch Keys 3 and 4 cannot be used for One Touch
operation.
1. Start Up
Upon powering up (Battery connection) push 2 + 5 keys to set the Base Key
Option setting. The following screen displays along with a confirm tone.
Figure 2-4 Base Unit Controls and Functions
17. Cordless 19. Desk
18. Power LED 20. Stand
17
19
18
20
Modular Jacks
FRONT VIEW
BACK VIEW
Power Adapter
Dterm Cordless DECT.book Page 6 Friday, December 7, 2007 3:48 PM