D
term
Cordless DECT Document Revision 1
Owner’s Guide 6 - 13
___________________________________________________________________________________
___________________________________________________________________________________
2.11 Handsfree
Press the Speaker key in Standby Mode or during Talk Mode. The Handset
goes into Handsfree Talk Mode and the Handsfree icon is turned on.
Press TALK key in Handsfree Talk Mode. The Handsfree icon is turned off and
goes into Talk Mode.
Press the Speaker key in Handsfree Talk Mode. The Handset disconnects the
conversation and goes into Standby Mode.
2.12 Headset
To put the handset into Headset Mode:
Insert the Headset plug in Headset Jack in Talk Mode or Handsfree Talk
Mode. The Handset goes into the Headset condition.
2.13 Volume Setting
The following modes have volume settings: Talk Mode, Handsfree Talk Mode
and Headset.
During each mode, the user can press the Volume Up or Volume Down keys
to increase or decrease the volume. As the user increases/decreases the
volume setting, the setting is displayed on the LCD from Level 1 to Level 6.
After the volume is changed, the LCD shows the current volume setting for
five seconds.
The LCD shows the current volume for two seconds after changing the mode or
condition.
If messages are sent from a PBX, the LCD shows the message after the
volume display.
2.14 Ring Volume Setting
2.14.1 Ringer Tone/Volume Selection
When the Volume Up key is pressed in Standby Mode or Incoming
Call Mode, the Handset goes into Ringer Volume Setting Mode and
the current setting is displayed on the LCD.
Dterm Cordless DECT.book Page 13 Friday, December 7, 2007 3:48 PM
To Next Page
Loading...
