NEC Dterm DTL-8R-1 - Dial out Using One Touch Dial; Exit Menu

6 - 20 Setup and Operation
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1 D
term
Cordless DECT
2.20 Exit Menu
To exit Programming Mode:
1. Select “Exit” and press the MUTE(Menu) key; the Handset goes into
Standby Mode.
2.21 Dial Out Using One Touch Dial
1. Press the TALK key on the Handset.
2. When connected, the Talk icon is turned on and displays the current
volume for two seconds.
3. Press the One Touch Dial key, the number that is registered is
displayed and is sent to the Base Station.

An error tone is emitted when the Handset does not have the one touch dial
number entered.
 A one-touch key will not work if a digit has already been dialed from the handset
keypad.
One Touch Dial Settings
▼
Exit
Dterm Cordless DECT.book Page 20 Friday, December 7, 2007 3:48 PM