3 - 6 Installation
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1 D
term
Cordless DECT
7. Plug the AC adapter into a standard 120 Vac wall outlet.
Do not use an outlet controlled by a wall switch.
5.2 Mounting the Base Directly to the Wall
If a standard wall plate is not available, mount the telephone directly on the
wall. Before mounting the telephone, consider the following:
Select a location away from electrical cables, pipes, or other items
behind the mounting location that could cause a hazard when inserting
screws into the wall.
Make sure the wall material is capable of supporting the weight of the
base unit.
Use #10 screws with anchoring devices suitable for the wall material
where the base unit will be placed.
To mount the telephone:
1. Insert two mounting screws 3-15/16" apart. Allow 3/16" between the wall
and screw heads for mounting the telephone.
Figure 3-8 Plugging the AC Adapter into the AC Wall Outlet
Dterm Cordless DECT.book Page 6 Friday, December 7, 2007 3:48 PM
To Next Page
Loading...
