D
term
Cordless DECT Document Revision 1
Owner’s Guide 4 - 3
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 2BASE UNIT CONTROLS
The Base Unit allows users to switch between the D
term
Cordless DECT phone and
the wired (desk) phone by using the Desk/Cordless buttons on the unit.
The Base Unit has three LEDs. The operation status of the LEDs are listed below.
Power LED
T Base is powered on: On (Blue LED)
T Base is powered off: Off
NEC Multiline Terminal LED
Manual press of the button will initialize the NEC multiline terminal.
Cordless LED
Manual press of the button will switch control to the cordless handset.
Ringer Volume Key
Press the Ringer Up/Ringer Volume key on the side of the handset to increase
the volume level during the Standby Mode:
OFF-Vibrate
Low
High
The LCD displays the current volume setting for two seconds.
If Ringer is set to OFF-Vibrate while in the charging cradle, the headset will ring
low.
Ringer Volume Key Pressing and holding the Ringer Down/Ringer Mute key, on the left side of the
handset, mutes the Ringer.
During the ring cycle, press and hold this key to mute the ringer.
Headset Jack Insert the Headset plug into the handset jack during Talk or Handsfree Mode.
Use corresponding handset keys to activate headset.
Table 4-1 Handset Control Functions
Condition Action
+
–
Dterm Cordless DECT.book Page 3 Friday, December 7, 2007 3:48 PM
To Next Page
Loading...
