NEC Dterm DTL-8R-1 - NEC PBX OPERATION

D
term
Cordless DECT Document Revision 1
Owner’s Guide 6 - 5
___________________________________________________________________________________
___________________________________________________________________________________
1.1.4 Training Mode (0 Key – No Function)
When 0 is dialed during Training Mode, a key touch tone is emitted
and the functions do not work (e.g., NEC PBX).
1.1.5 Training Mode (TALK Key or Speaker Key – Exit from the Training
Mode)
When the TALK key or Speaker key is pressed at any time during
Training Mode, a key touch-tone will be emitted and the “Training off”
command is sent to the PBX Expansion board. The Handset exits
from Training Mode.
SECTION 2 NEC PBX OPERATION
This operation is one of the examples for the DTL-8R-1 with an NEC PBX. As a
result, it might be different from actual operation on your system. Operation of
DTL-8R-1 in digital mode depends on each PBX specification.
F1=FNC
[▼ ] press up ke
y
F1=ANS
[▼ ]
press up ke
y
F1=LK01
Dterm Cordless DECT.book Page 5 Friday, December 7, 2007 3:48 PM