NEC Dterm - Using the NEC Multiline Terminal; Programming Mode

Issue 1 NEC America, Inc.
4 - 6 Dterm Cordless Handset
S
ECTION
4
U
SING THE
NEC M
ULTILINE
T
ERMINAL
Programming Mode
To assign function keys (F1~F4) and off-hook ringing:
1. Press and hold down
k
and
#,
then press the
talk
key.
2. Press the
chan
key repeatedly to scroll through the line
key (LK) and feature options for function key
F1
.
3. Press the
vol
key to select the displayed line key or
feature.
4. If a Line Key has been assigned, press the
chan
key to
turn Off-Hook Ringing ON or OFF. The LCD will indicate
/TALK
for ON or
/NO TALK
for OFF.
5. Press the
vol
key to advance to the next function key
(
F2 ~ F4
).
6. After programming
F4
, press the
vol
key to advance to
Global Off-Hook Ringing Assignment.
7. Press
chan
to turn Global Off-Hook Ringing ON/OFF
(LCD indicates ON or OFF as appropriate).
8. Press the
talk
key to exit.
Note 1:
Function keys (
F1 ~ F4
) can be programmed as Line
Keys 1~16, Redial (LNR/SPD), Answer (ANS),
Feature (FNC), or Recall. When assigned, these keys
operate the same as on an NEC Multiline Terminal.
Note 2:
When initially installed, function keys (
F1~F4
) default
to Line Keys 1~4 respectively and Off-Hook Ringing
defaults to ON.
Note 3:
Global Off-Hook Ringing must be set to ON (default) if
any function key is to operate with Off-Hook Ringing.