Installing the Operating System with Express Setup 5-35
Installing SCSI Controller Driver
If you utilize SCSI controller driver (N8103-65F/75F), install it according to the following
procedure:
1. Start [Device Manager] from [Start] menu → [Control Panel]→ [Administrative Tools] →
[Computer Management].
2. Double click the SCSI Controller driver which Device Manager lists as unknown device.
3. Click [Update Driver].
4. When the "Update Device Driver Wizard" appears, select "Display a list of the known
drivers for this device so that I can choose a specific driver" and click [Next].
5. Select [SCSI and RAID controllers], Click [Have Disk..].
6. Insert "Windows 2000 OEM-DISK for NEC EXPRESSBUILDER" into the floppy disk
drive, enter "a:\" into "copy manufacturer's file from:" and click [OK].
7. Specify the following driver and click [Next].
[INITIO INI-A10XU2W PCI SCSI Controller] (When N8103-65F board is installed.)
[Adaptec SCSI Card 29320ALP -Ultra320 SCSI] (When N8103-75F board is installed.)
The installation of the driver is completed.
Restart the system according to the message appeared on the screen.
To Next Page
Loading...
