Maintenance 7-11
RELOCATING/STORING THE SERVER
Follow the procedure below to relocate or store the server:
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-8 for details.
■ Never attempt to lift the server only by yourself.
■ Do not install the server in any place other than specified.
■ Do not connect/disconnect any interface cable with the power cord of the
server plugged to a power source.
IMPORTANT:
If the server needs to be relocated/stored due to a change in the floor
layout to a great extent, contact the sales agent.
Make sure to make a backup copy of your valuable data in the hard
disk, if any.
Make sure not to apply a shock to hard disks to relocated the server
if the contains any.
1. Take a floppy disk and a CD-ROM out of the server, if any.
2. Power off the server (the POWER/SLEEP lamp goes off).
3. Unplug the power cord of the server from a power outlet.
4. Remove all the cables from the server.
5. Hold the server by its bottom with at least three persons to carry the server.
IMPORTANT: Do not hold the front door to lift the server. The
front door may be disengaged from the server, causing personal injury.
6. Protect the server with the shock-absorbing materials, and pack it securely.
To Next Page
Loading...
