Troubleshooting 8-35
OFF-LINE MAINTENANCE UTILITY
The Off-line Maintenance Utility is an OS-independent maintenance program. When you are
unable to start the OS-dependent NEC ESMPRO to troubleshoot a problem, the Off-line
Maintenance Utility can be used.
IMPORTANT:
The Off-line Maintenance Utility is intended for use of your sales
agent. The NEC EXPRESSBUILDER CD-ROM and the Off-line
Maintenance Utility Bootable FD you have created contain a file
that describes operation of the utility, but do not attempt to use the
utility by yourself. Contact your sales agent and follow
instructions.
Starting the Off-line Maintenance Utility disables any access from a
client to the server.
Starting the Off-line Maintenance Utility
The Off-line Maintenance Utility may be started in the following ways.
From the CD-ROM
Set the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and reboot the
system.
After the menu is displayed on the screen, select "Tools" - "Off-line Maintenance Utility".
The Off-line Maintenance Utility program starts from the CD-ROM.
From the floppy disk
Set the Off-line Maintenance Utility Bootable FD in the floppy disk drive and reboot the
system.
The Off-line Maintenance Utility program starts from the boot disk.
The Off-line Maintenance Utility Bootable FD is created by selecting "Tools" - "Create
Support FD" on the NEC EXPRESSBUILDER.
Manual start (by pressing F4)
When the Off-line Maintenance Utility is installed, press F4 while the start-up screen of
the server is on screen. The Off-line Maintenance Utility starts from the hard disk.
To Next Page
Loading...
