9-18 Upgrading Your Server
4. Connect two power cords to the AC inlets.
Use the standard power cord coming with the server and the cord coming with the power
supply. The Power lamp (green) blinks when the power cords are connected.
5. Turn on the power of the server.
The Power lamps on the power supplies go on.
6. Make sure that any error on the power supply occurs with the status lamp and POST.
See Chapter 8 for details of error indications.
When the power lamp of the power supply is off, reinstall the power supply. If the
power lamp is still off, contact your service representative.
Power lamp Power failure lamp
To Next Page
Loading...
