Upgrading Your Server 9-49
Installation
Follow these steps to install the RMC.
1. See section "Preparing for Installation and Removal" described earlier to prepare.
2. Pull out the server from the rack.
3. Open the logic cover.
4. Adhere the shock absorbers to the back of the RMC.
Refer to the manual that comes with the RMC for detail location.
5. Insert the RMC into the RMC connector.
Align the notch in the bottom of the RMC with the keyed socket on the RMC connector.
6. Press down the RMC until it locks.
To Next Page
Loading...
