Configuring Your Server 4-9
ā Embedded Video Controller submenu
Option Parameter Description Your Setting
Onboard VGA
Control
Disabled
[Enabled]
If Disabled, the BIOS will hold the
embedded chip in reset. In this
configuration, the controller hardware is
completely disabled, and will be invisible to
the PnP operating systems.
[ ]: Factory-set
Option Parameter Description Your Setting
PCI Slot 1 Option
ROM ā PCI Slot 6
Option ROM
[Enabled]
Disabled
Enable option ROM scan of the selected
device.
When the graphics accelerator board is
installed or the disk array controller or SCSI
controller boards to be installed are
connected to the hard disk in which OS is
installed, set this item to "Enabled." When
the LAN controller board with installation of
the option ROM BIOS is used but the board
does not provide network booting, set this
item to "Disabled."
[ ]: Factory-set
To Next Page
Loading...
