1-18 System Overview
Device Module
The device module supports two standard PC AT compatible peripheral devices (see
Figure 1-11), as follows:
!
One IDE 3.5-inch high-capacity super floppy disk drive (supports 720 KB, 1.44 MB,
and 120 MB diskette media).
!
One 24X CD-ROM drive.
B
C
A
High-capacity super floppy disk drive
B
24X CD-ROM drive
C
Device module
Figure 1-11. Device Module
The device module is a single CRU that is not hot-pluggable.
Optional Components
Optional components are described in the following subsections.
Tape Drives
In the tower system only, two tape drive module bays are available for mounting
optional half-height 5.25-inch tape drives. As a prerequisite to installing the optional
tape drives an optional internal device bay kit must be installed first.
The tape drives are numbered 1 and 2, left to right as viewed from the front of the
system.
Monitor, Keyboard, and Mouse
The system does not require a monitor, keyboard, or mouse for most server
management functions other than the initial boot, system upgrading, or system
troubleshooting.
USB-compatible keyboard and mouse connectors are available on the rear of the
system.
Support for a colored VGA monitor is also available by using the VGA monitor
connector available on the rear of the system.
To Next Page
Loading...
