NEC Express5800 320La - Installing the Internal Device Bay Expansion Kit

4-54 CRU Replacement and Server Upgrades
Installing the Internal Device Bay Expansion Kit
1. Mount the power supply unit by placing it at the rear of the tape drive
module frame and engaging its bottom mounting tabs with its corresponding
frame brackets, and then secure it with two screws. See Figure 4-65.
Figure 4-65. Mounting the Power Supply Unit
2. Connect the device DC power distribution cable and the white/black cable
(Power Good sensor cable) coming from inside the server (taped to the
bottom of the tape drive module frame) to the power unit. See Figure 4-66.
A
B
A
Device DC power distribution cable
B
White/black cable (PowerGood sensor cable)
Figure 4-66. Connecting the Device DC Power Distribution and White/Black Cables