4-60 CRU Replacement and Server Upgrades
Installing a 5.25-inch Tape Drive
Install a 5.25-inch tape drive as follows.
Note:
All removable media SCSI devices being installed
must have their terminators either disabled or removed.
1. To prepare the tower-based unit and tape drive module for installing a tape
drive, perform the Preparation procedures in subsection Installing the
Internal Device Bay Expansion Kit.
2. Each empty device bay has a dummy cover and a bracket assembly. From
the device bay where you want to install a tape drive, remove the two screws
securing the device bay bracket assembly to the tape drive module chassis.
See Figure 4-73.
3. Remove the device bay bracket assembly. See Figure 4-73.
A
B
A
Screws (2)
B
Device bay bracket assembly
Figure 4-73. Removing the Device Bay Bracket Assembly
To Next Page
Loading...
