4-20 CRU Replacement and Server Upgrades
2. Repeat step 1 above if another VRM is to be installed. Otherwise, go to the
next step.
3. Reinstall the top cover of the CPU module. See Installing a Processor
earlier in this chapter.
Removing a Processor or Terminator Board
1. Remove the appropriate CPU module from the server chassis. See Removing
a CPU Module earlier in this chapter.
2. Remove the top cover of the CPU module. See Installing a Processor earlier
in this chapter.
3. Locate the processor or terminator board socket on the CPU board. See
Installing a Processor earlier in this chapter.
4. If you are removing a terminator board, refer to Installing a Processor
earlier in this chapter. Otherwise go to the next step.
5. Remove the heat sink from the top of the processor by inserting a small
screwdriver into the slot on its wire clip bracket and release the wire clip
bracket. See Figure 4-20.
Screwdriver Slot
Figure 4-20. Removing the Processor Heatsink
6. Swing its processor socket lever up until it is in the unlocked position and
carefully remove the processor. See Figure 4-21.
Figure 4-21. Removing the Processor
To Next Page
Loading...
