4-12 CRU Replacement and Server Upgrades
Figure 4-8. Removing the CPU Module
Installing a CPU Module
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Position the locking handle on the front of the CPU module in the down
unlocked position. See Figure 4-9.
3. Support the CPU module with both hands and carefully slide it into the
chassis until it is firmly seated in its connector.
4. Push the locking handle all the way up to its locked position.
5. Insert and hand-tighten the knurled screw that fastens the locking handle to
the CPU module.
Note:
Hand-tighten the knurled screw only as much
required to activate the interlock switch that allows power to
be applied to the CPU module.
To Next Page
Loading...
