NEC G355 - Configuring Mandown Calls (I755 Only); Setting the Mandown Mode

Telephone settings
187
Configuring mandown calls (I755 only)
To be able to use the mandown feature on the I755DECT Handset you
need to configure the various items related to this feature.
Access the mandown feature settings by:
1. Open the Calls menu as shown in Accessing
the Calls settings menu (page 174).
2. Highlight the Mandown call option.
3. Press the Select soft key.
Depending on the required action continue with
the appropriate step 4:
Setting the Mandown Mode (page 187)
Defining the Mandown Message (page
188)
Defining the Mandown destination (page
189)
Setting the Mandown Auto answer mode
(page 189)
Setting the Mandown Delay (page 190)
Setting the Mandown Prealarm time (page
191)
Setting the Mandown Mode
If you enable the mandown feature, a voice or message call is set up to
the defined destination when the handset remains in the horizontal
position for longer than the configured pre-alarm time.
To enable or disable the mandown feature, perform the following steps: