19
Projection of Images (Basic Operation)
3-3. Step 2: Selecting the title of input signal
1Turn on the power to a PC or other source connected to your
projector.
2 Press the MENU button.
3 Press the SELECT button to display “Source Select” on the
LCD screen.
• At each press of the SELECT button, the display will cycle as “Source Select” ←→
“Setup” ←→ “information.”
4 Press the SELECT button.
The title of input signal is displayed.
• When you have made a wrong selection, press the SELECT
button. A return will be made to
the previous menu.
5 Press the SELECT button to display the “title of the signal to
be projected” on the LCD screen.
6 Press the ENTER button.
The title of the signal to be projected is selected.
• The “(*)” mark on the liquid crystal display indicates that this is the currently selected item.
To Next Page
Loading...
