31
Adjustment Menus
䢇 GPIO Control
Set this control to “Enable” when the projector is to be controlled by the External Control terminal
(GP I/O). With “Enable” set, the projector does not accept commands issued using the control
panel buttons, remote control unit or computer.
䢇 Turret
Control of the turret to which the anamorphic lens is mounted.
䢇 MMS Control
Control of input signals when a separately sold MMS 1000 is connected.
䡵 Connection
The transmission speed (bps) is selected for your projector and a PC when they are connected by a
commercially available RS-232C straight cable.
Make a selection from among 4800/9600/19200/38400.
䡵 Title Setup
This is for the setting of input signal.
䢇 Title Select
Set an input terminal and various modes for the saved title.
• Signal Port Select ......... Select an input terminal.
• Signal Config ................ Please request your dealer/distributor to make this setting.
• Data File Select............. Select “PCF” File, “MCGD” File or “Screen” File.
䢇 Title Make
The title of input signal is saved.
Up to 14 alphanumeric characters can be entered.
Up to a hundred titles can be saved in your projector.
䢇 Title Delete
The saved title is deleted.
䢇 Create File
This is a function for setting various data for signals to be projected.
Please request your dealer/distributer to perform the setting.
䢇 Factory Default
The settings are reset to the ones at the shipment of your projector from the factory.
• All Data ............. Reset all the settings to the ones at the shipment from the factory.
• Only Title ........... Reset the title settings only to the ones at the shipment from the factory.
To Next Page
Loading...
