20
Projection of Images (Basic Operation)
3-4. Step 3: Adjusting the position and size of projected screen
䡵 Displaying the test pattern
1 Press the TEST button on the remote control.
The mode for selecting the test pattern is set.
2. Press the SELECT button.
The display of the test pattern name on the liquid crystal display switches.
3. Display on the liquid crystal display the name of the test pattern to
be projected, then press the ENTER button.
• To cancel the test pattern display, select a different signal to be projected.
䡵 Adjusting the position of projected screen (Lens shift)
1 Press the LENS SHIFT
buttons while depressing the CTL
button, on the control panel of your projector as required.
The position of the projected screen will move downward, upward, left or right.
To Next Page
Loading...
