12
1. What’s in the Box? and the Names of the Projector Parts
8. Remote interlock connector (inside front of projector)
This port is for safely using the laser in this device. It is used to externally control the laser illumination in the projector.
Consult with your dealer/distributor about using this.
9. Lens (optional)
Images are projected from the lens. Request your dealer/distributor to install or replace the lens.
Do not cover the air inlets and outlet while the projector is in operation. Insufficient ventilation leads to a rise of
the internal temperature and may cause a fire or malfunction.
1-3-2. Rear of the projector
1
2
3
1. Air inlet / Air lter
The air inlet for cooling inside the projector. Do not cover.
Two filters are attached over the air inlet to prevent dust. Refer to “5-3. Cleaning the Air Filters” (page 49) on how to clean the
air filters.
2. Air outlet
The air outlet to exhaust heat inside the projector. Do not cover.
3. Buzzer (inside rear of projector)
The buzzer rings when the power is turned on or an error has occurred.
NOTE
Do not cover the air inlets and outlet while the projector is in operation. Insufficient ventilation leads to a rise of
the internal temperature and may cause a fire or malfunction.
To Next Page
Loading...
Need help?
General
