NEC NC1201L-A - Selecting Input Signal Title

27
3. Projection of Images (Basic Operation)
3-3. Selecting the title of input signal
This projector allows you to select pre-registered title (input signal) using the preset buttons on the control panel (up to 16
titles). Request your dealer/distributor for details on registering and changing titles. This section explains the steps for select-
ing registered titles.
1
Turn on the power to the image devices connected to the projector.
2
Press the MENU button.
3
Press the LEFT/RIGHT button to display “Title Select” on the LCD screen.
At each press of the LEFT/RIGHT buttons, the display will cycle as “Title Select” ←→ “Configuration” ←→ “(Title
Setup)” ←→ “Information.”
4
Press the DOWN button.
The title of the input signal is displayed.
• Whenyouhavemadeawrongselection,presstheUPbutton.Areturnwillbemadetothepreviousmenu.
5
Press the LEFT/RIGHT buttons to display “Title of Signal to be Projected” on the LCD screen.
6
Press the ENTER button.
The title of the signal to be projected is selected.
• The(*)markontheLCDindicatesthatthisisthecurrentlyselecteditem.