NEC NC1201L-A - Projector Specifications

67
6. Appendix
6-6. Specications
Model name NC1201L-A
Projection method 3 chip DLP Cinema® method
0.69-inch DC2K chip
Panel resolution 2048 x 1080
Light source Laser Diode
Screen sizes Max. 12 m @14ft-L / Screen Gain 1.8 (Depends on setup conditions)
Contrast ratio 1650:1 with DCI specified color representation
Lens adjustment function Motorized lens shift (vertical/horizontal), motorized zoom, motorized focus
Signal input ports When shipped from factory: Empty
(for mounting optional components) (Note 1)
External Control RS-232C (D-sub 9pin) x 1
GPIO port (D-sub 37 pin) x 1
Service terminal (stereo mini jack) x 1
3D CTL (D-sub 15 pin) x 1
USB (Type A) x 1
Remote interlock port x 1
Ethernet port (RJ-45) x 1
Power supply voltage AC 200 to 240 V, 50/60 Hz single phase
Input current 9.2 A
Power consumption 1304 W (Note 2)
Cooling method Cooling air system
Noise level Less than 47 dB
Installation Orientation: Desktop/front, Desktop/rear, Ceiling/front, Ceiling/rear
Net weight 66 kg (Excluding lens)
Dimensions 680 mm (W) x 860 mm (D) x 333 mm (H) (Does not including protruding portions, includes foot.)
Environment Operating temperature: 10 to 35°C
Operating humidity: 20 to 80% (non-condensing)
Storage temperature: -10 to 50°C
Storage humidity: 20 to 80% (non-condensing)
Operating altitude: 0 to 2600m/8500 feet
Regulations (Note 3) <Safety> <EMC>
Europe EN60950-1 EN55022 Class A, EN55024, EN61000-3-2/-3-3
Russia
Belarus
Kazakhstan
EAC, IEC60950-1 EN55022 Class A, EN55024, EN61000-3-2/-3-3
Oceania IEC60950-1 RCM, AS/NZS CISPR. 22 Class A
Asia IEC60950-1 EN55022 Class A, EN55024, EN61000-3-2/-3-3
Korea K60950-1 K00022 ClassA, K00024
K61000-3-11
Saudi Arabia SASO EN55022 Class A, EN55024, EN61000-3-2/-3-3
Japan J60950-1 VCCI Class A, JIS C 61000-3-2
(Note 1) The video input slots are empty when the device is shipped. Input ports can be added by mounting option boards,
which are sold separately. (See page 77)
(Note 2) The value is typical.
(Note 3) Certificated by latest edition as of 2014. Described the certification standard for laser products in “Important Information”
of this manual. (See page 2)
* Note that these specifications and design can change without prior notice.