21
2. Installation and Connection
Slide the clamper to the hilt of the power cable.
Pulling the knob in the arrow direction allows you to adjust the clamper position.
Once the clamper position is adjusted, release the knob to lock the clamper.
knob
Pull the band to hold the power cable.
Pulling the knob in the arrow direction allows you to adjust the band position.
Pull the top and bottom bands by keeping their balance.
Once the band position is adjusted, release the knob to lock.
knob
knob
This completes the attachment of the power cable stopper.
To Next Page
Loading...
Need help?
General
