NEC NLT-19HDDV3 - Connection to External Equipment; Connect to Aerial Socket; Watching VCR

Connection to External equipment
11
Connect to Aerial socket
-You can connect additional equipment, such as VCRs, camcorders etc. to your set. However please
check with your manufacturers instruction books for specific information. Make sure all connections
are made with both your set and additional appliance unplugged from the mains to avoid damaging
your equipment.
- Here shown may be somewhat different from your set.
Connect the RF out socket of the VCR to the aerial sock-
et on the back of the set.
Connect the aerial cable to the RF aerial in socket of the
VCR.
Store the VCR channel on a desired programme number
using the ‘Manual programme tuning’ section.
Select the programme number where the VCR channel is
stored.
Press the PLAY button on the VCR.
< Back panel of the set >
Watching VCR
Use the INPUT button on the remote control to select AV or S-Video.
Insert a video tape into the VCR and press the PLAY button on the VCR.
(See VCR owner’s manual).
- If you connect an S-VIDEO VCR to the S-
VIDEO input, the picture quality is improved;
compared to connecting a regular VCR to the
Video input.
-To avoid picture noise (interference), leave
an adequate distance between the VCR and
set.
S-VIDEO
OUT
IN
(R) AUDIO (L) VIDEO
S-VIDEO
IN
(L
) A
U
D
IO
(R
)
V
ID
E
O
M
O
N
O
A
V
2
IN
RL
AUDIO VIDEO
S-VIDEO
IN
L/MONO R
VIDEO
AV
IN
AV
, S-VID
EO
CO
M
P.
AUDIO
IN
< Back panel of the set >
< Back panel of VCR >